====== Tunnels and underground networks ====== Tunnels are useful to pass hills or mountains and also to build underground networks or undersea tunnels. ===== I.Simple tunnel ===== Select the tunnel tool and click on one of the extremity of the future tunnel, is the both facing extremities allow the construction of a tunnel entry, the tunnel is built :{{ :fr:tunnel01.jpg }} ===== II.Complex constructions ===== ==== 1.Choose the adapted view ==== As seen in the tutorial [[http://www.simutrans-france.fr.nf/doku.php?id=en:interface|Settings and interface]] there are two ways to see under the ground. To have a global looking at the underground networks, it's better to use the normal underground view keyboard shortcut "shift+u", to build easily an underground network in one or more layers you'd better use the layer sliced view :{{ :fr:tunnel02.jpg }} Build under the ground with the global undergroun view is possible but not very practical. ==== 2.Build a complex underground network ==== It's possible to build just a tunnel entry instead of a complete tunnel by holding down ctrl key while building :{{ :fr:tunnel03.jpg }}Then the underground constructions are the same as ground's ones but instead of using a way tool you have to use the tunnel tool which works the same way :{{ :fr:tunnel04.jpg }} Then you can build stations, signals and electrifications as you want. ==== 3.Underground slopes ==== To make an underground slope, use first the adapted artificial slope tool on a way extremity to make a down or up slope.{{ :fr:tunnel05.jpg }}Then vary the height of the layer sliced view to go to the lower or higher layer and extend the network.{{ :fr:tunnel06.jpg }} ==== 4.Undersea tunnels ==== You can build undersea tunnels by the same way but of course you have to take care of the sea deepness : more the sea is deep and more the tunnel must be deep.{{ :fr:tunnel07.jpg }} Next tutorial : [[http://www.simutrans-france.fr.nf/doku.php?id=fr:elevatedway|Elevated ways]]